Product
Barbed wire
Galvanised barbed wire plus Y/L arms, tension wire, clips and fixings — the whole line from one supplier.
Overview
The components that complete the line

Barbed wire
Barbed wire is made by twisting two galvanised steel wires together and winding short lengths of wire around the twist at regular intervals to form the barbs. It is less of a deterrent than razor wire, but because it is economical, easy to transport and quick to install, it is an indispensable complement to any fencing system. It is mostly used along the top of fence lines as an extra layer beneath concertina or flat razor wire, and on its own as boundary wire on farmland and pasture.
Twist types
In the conventional twist, the two wires are twisted in one direction and the barbs are wound over the twist. In the reverse-twist type, the wires change direction after each barb; this stops the barbs from sliding and gives a straighter line when the wire is tensioned. Barbs are usually two- or four-point; the four-point type offers greater deterrence.
Installation accessories
The service life and effectiveness of a perimeter line depend heavily on choosing the right accessories. STALBORG supplies the fixings needed for razor and barbed wire systems within the same project, in compatible materials and coatings:
- Y arm: Mounted on the post head; concertina sits between its two wings, and rows of barbed wire are strung along the wings.
- L arm (45°): A single arm angled outward or inward from the fence, for barbed wire and flat razor wire.
- Tension wire: Galvanised wire strung along the line so concertina and flat wire hold their shape.
- Tensioners: Ratchet tensioners and fittings for adjusting tension-wire tension.
- Clips and tie wire: For securing razor wire to the tension wire and arms.
- Stakes and ground anchors: For securing concertina lines laid on the ground.
Applications
Main applications include fencing around industrial plants and warehouses, farmland and livestock areas, construction sites, railway and roadside boundaries, and the outer perimeter lines of military and public facilities.
Typical line layout
In a common industrial perimeter, Y arms are fitted to the post heads of a panel or chain-link fence. Three rows of barbed wire are strung along each wing, and a concertina coil attached to tension wires sits between the wings. For more economical solutions, outward-angled L arms with two to four rows of barbed wire are used instead. The right layout depends on the threat level, fence height and relationship with neighbouring plots.
Selection guide
For barbed wire, wire diameter and coating life are the deciding factors; in coastal and industrial atmospheres, choose wire with a heavier coating weight. For accessories, the arm angle must suit the fence design, fixing dimensions must match the post section, and the coating should be the same as that of the wire on the line — mixing different metals can cause galvanic corrosion. Given the line length, post spacing and number of rows, the STALBORG team draws up a complete bill of materials including every accessory.
Technical data
Typical specifications
- Wire diameter
- 1.6 – 2.8 mm (line and barb)
- Barb spacing
- 75 – 150 mm
- Barb type
- 2- or 4-point
- Twist
- Conventional / reverse twist
- Roll length
- 100 – 500 m (by wire diameter)
- Coating
- Hot-dip galvanised; other coatings by project
- Accessories
- Y arm, L arm (45°), tension wire, ratchet tensioner, clips, tie wire, stakes
- Note
- Typical values; they vary by project and specification.
Applications
Where barbed wire is used

Extra fence-top layer
An economical complementary row beneath razor wire.

Industrial plants & warehouses
Along the top of chain-link and panel fences.

Construction sites
A temporary, economical perimeter line.

Military & public outer perimeters
The outer line of layered perimeter security.
Get a barbed wire & accessories quote
Share the line length, post spacing and number of rows.
